[blinkyt]

Much appreciated goodweather, and I really look forward to reading the new guide when you release it. Thankyou, or rather I should say Merci Beaucoup 🙂

blinkyt

[blinkyt]

Could it be because the panel is coded to use a particular midi channel? I had a similar experience with another panel, the Kiwi-3P, and spent a while trying to figure out the same thing before remembering I had read on the posts related to that panel about the midi channel being set to use Midi channel 1 only, and since I had previously set up my Kiwi Technics modded JX-3P on channel 3 it wasnt working no matter what I did.

Check the code of the panel you are using to see if it is set on a specific channel, or email the developer of the panel to see if he can help.

Good luck and let us know what the reason was if you do find out 🙂

• This reply was modified 6 years ago by blinkyt.

[blinkyt]

Hi Puppeteer, thanks for the reply. Yes I had a feeling it might be a bit more complicated than I hoped 🙂 I’ll have to read up a bit on LUA coding and how to best to do this. I did see that excellent Step By Step Guide written by Goodweather so will give that a proper read when I can. So yes replacing the b0 with a midi channel variable and then adding a modulator for that will take longer to do but once done it is there for whenever the Kiwi-3P channel needs to be changed 🙂

Thanks again and I will come back to this thread if I get any further on with that.

• This reply was modified 7 years ago by blinkyt.

[Author]

Posts