CTRL NRPN basic programming

[ungleichklang]

HI,

I’m new to CTRL and NRPN so my question might seem very basic …
I try to make a CTRL Interface for the MIDIbox CV V2
TK uses NRPN in his Lemur Interface to control everything, so I got his NRPN list and try to implement it into CTRL …
I also had a look at the DSI MOPHO panel to get some deeper understanding of NRPN in CTRL ..
If I get it right, I only have to set the “Midi Message Type” to “MULTI”
and the decimal value of the NRPN as “Midi Control Number” and insert the predefined Messages as NRPN??

If I do that I get
CC,ByteValue,MSB7bitValue,99,-2
CC,ByteValue,LSB7bitValue,98,-2
CC,ByteValue,MSB7bitValue,6,-1
CC,ByteValue,LSB7bitValue,38,-1

on all controllers … is that correct?? Do I have to ad the HEX value of the NRPN somewhere??

Are there some other CTRL Demos on NRPN??

greetings from belgium, Sascha

[ungleichklang]

just for the note: I use CTRL version 5.3.0 on a Mageia Linux

[atom]

There are templates for NRPN/RPN/NPRN-Korg messages in the property editor for MULTI messages, hover over those icons, and click on it (it’s the second icon, insert pre-defined)

[ungleichklang]

Thanks atom, I did that and got ..

CC,ByteValue,MSB7bitValue,99,-2
CC,ByteValue,LSB7bitValue,98,-2
CC,ByteValue,MSB7bitValue,6,-1
CC,ByteValue,LSB7bitValue,38,-1

for all controllers .. no matter what CC-Value I added before ..
because your DSI MOPHO Panel shows the same I think I’m heading into the right direction.

[wikter]

…what means that “-2”??

MVXSynths
R3 / MOX6 / Electribe2 / Electribe R MkII / Electribe MX / K4R / BCR2000 / XStation61 / XStation25 / Virus Rack / Chameleon / Proteus 2500 / RM1X / KN2600

[Author]

Posts