Home Forums General Using Ctrlr Image as a knob with UiImageSlider

This topic contains 1 reply, has 2 voices, and was last updated by layzer layzer 3 years, 5 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #16938

    technolife
    Participant

    Hi Everyone,

    I’m new at Ctrlr, and I’l like to thank the Dev ! 🙂
    I’m trying to get my image rotate like a Knob, so I used knobman an I made an image with 127 frames (64 Width/64 Height) with a line that turn (360°).
    I exported it as a vertical (but I also tried with horizontal) stitched/png animated, then I set it as the ressource of my uiImageSlider and set the width and height as 64. The cursor is set to normal and RotaryVerticalDrag.

    But at last, I can’t get my image rotate…

    Any Ideas ?

    Thanks in advance.
    (Sorry for my bad english, I’m French)

    #16942
    layzer
    layzer
    Participant

    if the knob animates fine in knobman, export it as a vertical stitch png file with alpha. also, make sure frames rendering is your 127 value, not the preview value.

    check your exported image with a paint program to make sure its a long skinny picture.

    good luck

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Comments are closed.