[Blutwurst01]

Hey human fly

Thank you very much for your help. The cutoff from the synth lite II panel works for me! It works like this now: The parameter has a max value of 16383. If I increase the value of the parameter by one, CC48 also increases by one. When CC48 reaches 127, it jumps back to 0 and CC16 increases by one (and so on..). With this method the parameter has bigger resolution than the cutoff of the synth, but it still works. Now I have to increase the value of the parameter by 64 until the cutoff of the synth increases by one. I hope you understand what I mean.

Is there a way to tell CC48 to alternate between 0 and 64 and don’t increase just by one? So every step CC48 increase by 64? That would be perfect. Then the parameter only has a resolution of 256 and not 16384. This would be better for automation etc.

The BS II does not only have 14bit messages. It has normal CC messages, NRPN messages and those like I explained. Here are all messages listed in this manual: http://media.aadl.org/files/catalog_guides/1447741_instructions.pdf#page=20&zoom=110,-869,8

Greetings

[Blutwurst01]

Did you figure it out? I have the same problem now!

[Author]

Posts