[sobaboy]

"SirSickSik":1y1y3dtl wrote:

F0 0F 40 00 01 00 00 01 00 0U 00 PP 00 00 VV VV F7

the message I used with my remotezero controller is:
0F 40 00 00 01 00 01 00 00 01 33 DV
[/quote:1y1y3dtl]

The Ensoniq DP/4 breaks up it’s parameters into 4-bit nybbles and sends then as the lowest 4-bits of an 8-bit byte.

Your value 00 00 VV VV should be expressed as 0V 0V 0V 0V

From what I have experienced with the Novation Remote Zero SL, you can’t break up a value in that fashion.

This is what Ctrlr is for. ” title=”Very Happy” />

[sobaboy]

The new version works fine. Just additional features of the AN200 are missing.

You must have a display bigger than 1920×1080 as the Toolbar in Ctrlr is not visible on my screen. I had to open the panel up in a text editor and change the coordinates of the toolbar to get it to show up on my screen.

Suggestions:

[list:1vafxe6f]
Make the panel smaller.
It would be nice to have it fit on a netbook screen with the Ctrlr menubar. ” title=”Very Happy” />

Name the Controls
This would be useful for automation.

Use Ctrlr tabs to move stuff like the Control Matrix off the main tab

Make the Waveform, PEG Osc Destination, VCF Filter Type, PWM Source and a few others Radio Buttons.
Create a set of buttons and assign them a Radio Group value greater than 0

Create a set of buttons for the LFO Assign Group parameter.
In the Yamaha AN200 editor this was a combo box list, but limited you to a specific set of assignments.

You might want to consider using CC Codes where they are available instead of SysEx.
Page 12 of the Data List book has a list of CC codes recognized by the AN1x when in Control Change Mode 1 and Mode 2.
Pages 118-119 of the AN200 manual, Section 1.2.18 of the MIDI Specification for the AN200 has a list of the CC codes for the AN200 in its NORM and ALL modes.

Noise, Ring Mod and Feedback could go with the 2 VCO level controls.

High Pass filter is before the main filter.

Maintain state of controls to affect other controls
The available Waveforms change depending on Sync state.
[/list:u:1vafxe6f]

Attached is a rough layout with various items put into Ctrlr groups. I have also placed the Control Matrix items in a Group and placed them on their own tabs. i have coloured controls that could be Radio Button groups green.

I am subscribed to the AN1x list as well.

I have made attempts at creating control maps for the AN200 on a Behringer BCR2000 and Novation Remote Zero SL.

Thanks for all the work so far.

[sobaboy]

I opened this up in Ctrlr 833 and the controls have the SysEx Formulas but the MIDI Message Type is set to CC.

Once I set all those controls to send SysEx and hooked up an AN200 they worked. I tested the Cutoff and Res.

[Author]

Posts