When you attempt to print a document with an HP printer, a Printer Error 49 will usually appear. This happens when a communication error between the computer and printer occurs. There are many possible causes that this error 49 code message may appear. It could be related to the file being printed or a firmware issue. To fix your printer, you must first determine what is causing the problem. This tutorial will show you how to fix printer error 49 in HP printers.
Incorrect print commands, corrupted or damaged data, or registry problems are common causes of HP printer error 49. wps pin hp printer Poor quality parallel cables connecting the printer and the computer can cause problems that are easily fixed. You must eliminate all possible causes of error messages.
To fix error 49 on an HP printer, you must first calibrate it. These steps will help you calibrate your printer:
- Clear the print job memory by pressing Cancel Job.
- Turn the printer off and then on again.
- Another job, but this time it will be from a different program.
- If the job printing went well, you can return to the original application and print another file.
- To get help from the vendor, contact them if the error message appears only in a particular software program or print job.
- If the error message continues to appear despite using a different software program or print job, you can remove all cables connecting the printer to your computer or network. Then turn off the printer.
- Open the printer, and take out the memory DIMMS or DIMMS of third parties. However, do not remove the firmware DIMM that was inserted into slot J1.
- You should also remove all EIO devices.
- Restart the printer.
- If the error message doesn’t appear again, return each DIMMS or EIO device one at a time and turn on the printer each time you insert a device.
- Replace any device you find.
- Connect all cables to re-connect the printer to the computer/network.
- If error code 49 persists, you can replace the DIMM firmware.
- Finally, you will need to replace the printer’s formatter and calibrate it again.
After calibrating your HP printer error you need to ensure that your Windows registry does not contain any errors. The registry is an essential component of Windows. It stores program and file settings that enable your operating system to remember how to load and use different programs. It is an important component of your system but can become damaged by the daily use it receives. A reliable registry cleaner can help you resolve any registry problems. “Frontline Registry Cleaner” is highly recommended. It can fix 99% of the system problems found in your computer, so you can use it in its best condition.
HP Printer Error20 occurs when your HP printer is not properly configured. This error occurs most often when you attempt to print a document from your system. Windows then discovers that your printer is not communicating with it correctly. This error could be caused by a damaged printer driver or incorrect printer settings. You must be able to fix any errors that caused this error to appear to correct it.
This format will often show the error.
- “Printer is not activated – Error code20”
To fix HP error 20 you must first address the problem that caused it. This error can be caused by several issues, including the printer not being set to default, missing printer drivers, and registry errors.
To fix this issue, you must first make the printer the default printing device of your computer. You can do this by clicking Start > Printers & Faxes and finding the HP printer. Then, right-click on it. This will allow you to print from the printer by selecting “Set as Default”. This is crucial because Windows will not be able to print anything unless it has opened the printer it wants. Problem is, Windows can get confused about which printer it should print from if the default printer isn’t selected correctly.